HARNESS AS-SWITCH 2701233 - Caterpillar

Installation Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     6V-3155     Brace Assembly     1    
B     138-7573     Link Bracket     2    Note: Cleanliness is an important factor. Before assembly, thoroughly clean all parts in cleaning fluid. Allow the parts to air dry. Do not use wiping cloths or rags to dry parts. Lint may be deposited on the parts which may cause trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement. Dirt and other contaminants can damage the precision component. Perform assembly procedures on a clean work surface. Keep components covered and protected at all times.Note: Check the O-ring seals, the gaskets, and the seals for wear or for damage. Replace the components, if necessary.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g01290448
Attach Tooling (B) and a suitable lifting device to hydraulic tank (10). The weight of hydraulic tank (10) is approximately 113 kg (250 lb). Position hydraulic tank (10) and install bolts (11). Connect hose (9).
Illustration 2 g01290444
Install clamp (6) and connect hose assembly (7). Connect hoses (5) and harness assembly (8) .
Illustration 3 g01290392
Connect hose assemblies (3) and (4) .
Illustration 4 g01290326
Attach Tooling (B) and a suitable lifting device to guard assembly (2). The weight of guard assembly (2) is approximately 68 kg (150 lb). Install guard assembly (2) .
Fill the hydraulic tank. Refer to Operation and Maintenance Manual, "Hydraulic System Oil - Change".
Illustration 5 g01290295
Remove Tooling (A) and lower the lift arms.