HARNESS AS-CAB 2782118 - Caterpillar

The RAPTOR software can be updated by loading a new program through the service port on the RAPTOR valve.
Explosion Hazard-Do not remove covers or connect/disconnect electrical connectors unless power has been switched off or the area is known to be non-hazardous.
Connect a serial cable between a computer and the RAPTOR assembly. The RAPTOR assembly has a male 9-pin Sub-D connector, and connects to the 9-pin COM port of a PC using a null modem cable (pins 2 and 3 cross over within the cable). Only pins 2, 3 and 5 are used (it is not a problem if the other pins are connected).Load the ServLink and Watch Window software on the computer. Follow the procedure supplied with the software.Activate the ServLink server and set the communication parameter. See server online documentation. RAPTOR parameters are:* Baud rate = 19200* Bus mode = Point to Point* Communication = 8N1Open a new net and wait until the net is displayed on the server screen. Start Watch Window. Right click on the Raptor TAB. A menu will pop up. Select load application, select the file and click "ok". Wait until Watch Window indicates that the application has been successfully changed.Read the documentation that is provided with the new "RAPTOR.SCP" file this may contain additional information about changes to be made to RAPTOR valve to work with the new software.
CAUTIONEnsure that the serial cable is removed and the port cover is replaced after the software upgrade is complete. Electromagnetic robustness to high strength fields is not ensured with a cable connected.An unsafe condition could occur with improper use of these software tools. Only trained personnel should have access to these tools.