HARNESS AS-SENSOR 2832853 - Caterpillar

Illustration 1 g01371445
(2) Accessory drive gear
(5) Thrust washer
(6) Idler gear (1) Bore in the sleeve bearings after assembly ... 75.000 0.055 mm (2.9528 0.0022 inch) (3) Thickness of new thrust washer ... 8.50 0.05 mm (0.335 0.002 inch) (4) Auxiliary drive shaft Diameter of new auxiliary drive shaft ... 74.900 0.015 mm (2.9488 0.0006 inch)Width of groove in new auxiliary drive shaft ... 8.750 0.025 mm (0.3445 0.0010 inch)End play for auxiliary drive shaft ... 0.175 to 0.325 mm (0.0069 to 0.0128 inch) (7) Sleeve bearing Bore in the sleeve bearing after assembly ... 90.000 0.010 mm (3.5433 0.0004 inch)Maximum roughness average (Ra) ... 0.8 micrometer (32 microinch)Note: After the sleeve bearing is installed in the gear the sleeve bearing must be machined to size. (8) Diameter of new shaft ... 89.880 0.020 mm (3.5386 0.0008 inch)