HARNESS AS-SENSOR 2848868 - Caterpillar

Illustration 1 g00285894
Illustration 2 g00285896
View A-A
Illustration 3 g00285897
View B-BCharging dimensions for a suspension cylinder which has been purged Charge with oil ... 12.7 mm (0.50 inch) Full charge of oil and nitrogen ... 103.6 to 116.3 mm (4.08 to 4.58 inch)Note: Refer to Testing and Adjusting, "Suspension Cylinder (Rear) - Purge and Charge" for the procedure on properly charging the rear suspension cylinders. (1) Outside diameter of 133-5618 Pin (4 places) ... 111.25 0.50 mm (4.380 0.020 inch) (2) Inside diameter of 9U-9558 Bearing ... 114.35 0.05 mm (4.502 0.002 inch) (3) 9T-2238 Valve Assembly Torque for the charging valve ... 50 10 N m (37 7 lb ft) Torque for the valve cap ... 4.5 1.0 N m (39.83 8.85 lb in) (4) Bore of head (2 lands) ... 279.48 0.03 mm (11.003 0.001 inch) (5) Diameter of rod assembly ... 279.32 0.05 mm (10.997 0.002 inch) (6) Bore of cylinder assembly ... 317.55 0.10 mm (12.502 0.004 inch) (7) Diameter of rod assembly (2 lands) ... 316.75 0.13 mm (12.470 0.005 inch)Lubricate the sealing lip with the lubricant that is being sealed.Note: Approximately 47.6 L (12.57 US gal) of SAE 10W oil with a service classification of CF is necessary in order to charge a cylinder.