HARNESS AS-WIRING 2851975 - Caterpillar

Uninterruptible Power Supply: UPSB505 (S/N: YTM1-UP)Introduction
This Special Instruction guides the user to install a temperature sensor on UPSB505. The temperature sensor is included with the Network Management Cards.Do not perform any procedure in this publication or order any parts until you understand the information that is contained in this publication.Important Safety Information
Work safely. Most accidents that involve product operation, maintenance, and repair are caused by failure to observe basic safety rules or precautions. An accident can often be avoided by recognizing potentially hazardous situations before an accident occurs.A person must be alert to potential hazards. This person must also have the necessary training, skills, and tools in order to perform these functions properly.Safety precautions and warnings are provided in this instruction and on the product. If these hazard warnings are not heeded, bodily injury or death could occur to you or to other persons. Caterpillar cannot anticipate every possible circumstance of a potential hazard.Therefore, the warnings in this publication and the warnings that are on the product are not all inclusive. Avoid using a tool, a procedure, a work method, or operating technique that is not recommended by Caterpillar. If used, ensure the safety of the operating personnel and others.Ensure that the product will not be damaged or the product will be made unsafe by the operation, lubrication, maintenance, or the repair procedures.
Do not operate or work on this machine unless you have read and understand the instructions and warnings in the Operation and Maintenance Manual. Failure to follow the instructions or heed the warnings could result in injury or death. Contact any Caterpillar dealer for replacement manuals. Proper care is your responsibility.
Included Items
The items in the table below are included in with the temperature sensor for use when installing.
Table 1
Item     Qty     Description    
5     6     Wire clip    
4     1     Housing clip    
6     1     Wall anchor #8    
3     5     Tie wrap 203-mm (8-in)    
7     1     Sheet metal screw #8 x 3/4-in    
-     2     Adhesive cable tie holder 19-mm x 19-mm (3/4-in x 3/4-in)    
2     1     Temperature/Humidity sensor mount 25.4-mm x 25.4-mm (1-in x 1-in)    Installing the Temperature Sensor
Note: If you use a tie wrap to secure the sensor, tighten the tie wrap over the recessed channel on the sensor. If you use the housing clip, make sure the protrusions on the inside of the clip snap into the slots in the recessed channel.Note: Use adhesive cable tie holders, tie wraps, and wire clips to secure the sensor cable.Installing the Temperature Sensor on Vertical Rail
Illustration 1 g02497036
Refer to Illustration 1 for installing the temperature sensor (1) on vertical rail in an appropriate place.
Install the sensor mount (2) into the vertical rail.
Positi