HARNESS AS-SENSOR 2898439 - Caterpillar

Installation Procedure
Verify that all of the components are clean and free of foreign material prior to installation. Inspect all O-ring seals and the components for wear. Replace the O-ring seals and the components, if necessary.
Lubricate all O-ring seals with the lubricant that is being sealed.
Illustration 1 g00613396
Position a suitable lifting sling around gear pump (2). Secure the lifting sling to a hoist. Position gear pump (2) to pump drive (7), as shown. The weight of gear pump (2) is 57 kg (125 lb).
Install four bolts (6) and the washers that hold gear pump (2) to pump drive (7) .
Illustration 2 g00613395
Connect two hose assemblies (4) and (5) to gear pump (2) .
Illustration 3 g00613391
Connect two hose assemblies (1) and (3) to gear pump (2) .
Fill the hydraulic tank with hydraulic oil. Refer to Operation and Maintenance Manual, "Hoist, Torque Converter, and Brake Tank - Change" for the correct procedure.
Refer to Operation and Maintenance Manual, "Lubricant Viscosities and Refill Capacities" for the correct refill capacity.End By:
Remove the wheel chocks. Refer to Disassembly and Assembly, "Wheel Chock (Front and Rear) - Remove and Install".
Remove the truck body retaining cable. Refer to Disassembly and Assembly, "Truck Body Retaining Cable - Remove and Install".