HARNESS AS-REAR 2899169 - Caterpillar

Service Brake - Use the service brake to slow down the machine ground speed for normal braking.Service Hour Meter (28)
Service Hour Meter - The service hour meter should be used to determine service hour maintenance intervals.Horn (29)
Horn - Depress the horn button to sound the horn.12V Socket (30)
Power Receptacle (12 volt) - A 12V socket supplies power equipment and is located left side steering column.Air Conditioner Control (31 If Equipped)
Illustration 8 g06276662
Air Conditioner Control - Press the top of the switch to activate the air conditioner. Press the switch to middle position to activate heater.Heater Control (32B If Equipped)
Illustration 9 g06276662
Heater Control - Press the top of the switch to activate the heater.Temperature Control (32A If Equipped)
Temperature Control - Turn the knob to the right toCOOL. Turn the knob to the left to WARM.Heater Control (32B If Equipped)
Heater Control - Turn knob to the right to increase heat. Turn knob to the left to decrease heat.Roading Lights (33)
Roading Lights - Press the left side of the switch to the right position to activate the position lights and the instrument panel lights. Press the switch all the way to the left to turn off the roading lights.Front Work Lights and Rear Work Lights (34 If Equipped)
Front Work Lights and Rear Work Lights - Press the left side of the switch to the middle position to turn on the front work lights. Press the switch all the way to the left to turn on the front work lights and the rear work lights. If switch is turned on more than 1 minute before key off, work lights will continue ON for 30 seconds.Hazard Flashers (35)
Hazard Flashers - Pressing the left side of the switch will cause the turn signal lights to flash continuously.Operator Information
To prevent injury, make sure that no people are working on the machine or near the machine. To prevent injury, keep the machine under control at all times.Reduce engine speed when you maneuver in tight quarters or when you are going over a hill.Select the necessary travel speed before you start downgrade. Do not change travel speed while you are going downhill.When you go downgrade, use the same speed to go upgrade.Do not allow the engine to over speed when you go downhill. Use the service brake to reduce engine over speed when you go downhill.When the load will be pushing the machine, put the speed control in SLOW speed before you start downhill.
Adjust the operator seat.
Fasten the seat belt.
Raise the work tools to negotiate any obstacles.
Push down on the service brake to prevent the machine from moving.
Release the parking brake.
Push the direction control switch for the desired direction.
Release the service brake.
Push down on the accelerator pedal until you achieve the desired engine speed.
Drive the machine forward for the best visibility and for the best control.Note: For operator comfort, stop the machine before any directional shifts are made. For maximum life of the power train components, stop the machine before any directional shifts are made.