HARNESS AS-WIRING 2907081 - Caterpillar

Illustration 4 g01720800
Position the machine on level ground in the service position. Refer to Illustration 4.
Stop the engine.
Release the pressure in the hydraulic system. Refer to Testing and Adjusting, "Hydraulic System Pressure - Release".
Attach 311-1362 Vacuum Cap onto the hydraulic tank. Attach an air supply hose onto the assembly. Apply 276 to 414 kPa (40 to 60 psi). This procedure will pull a vacuum on the hydraulic system.
Illustration 5 g03322997
Pump compartment
(29) Pressure tap (delivery pressure for drive pump)
(30) Pressure tap (delivery pressure for idler pump)
Connect 60000 kPa (8700 psi) pressure gauges to pressure tap (29) and pressure tap (30) for delivery pressure from both pumps.
Install the following tools in accordance with the flow meter tool layout and the circuit diagram. Refer to Illustration 3.
Disconnect line (6) and line (7) from boom cylinder (3).
Install O-ring seal (8) and plug (11) to the end of line (6) and line (7).
Install cap (2) on connector (1) for the boom cylinder lines.
Disconnect line (4) and line (5) from boom cylinder (3).
Install cap (2) on connector (1) for the boom cylinder lines.
Install O-ring seal (8), reducer (9), O-ring seal (10), connector (12), O-ring seal (13), and nipple assembly (14) to the end of line (4) and line (5).
Remove 311-1362 Vacuum Cap and install the filler plug for the hydraulic tank.
Connect portable hydraulic tester (21) and the test hoses between nipple assembly (14) on line (4) and nipple assembly (14) on line (5). Note: In order to avoid damage to the flow meter, make sure that the direction of oil flow is correct. The proper direction of flow is from line (4) for the boom cylinder head end, through flow meter (21), and return through line (5) for the boom cylinder rod end.Test
To prevent personal injury or equipment damage from failure of the hydraulic test equipment or associated circuit components because of blocked pump flow, make sure that the test equipment valves are fully open before starting the engine.
To prevent personal injury and/or equipment damage from failed lines or components while the hydraulic test equipment is returned to the open flow position, slowly open the hydraulic test equipment valve while monitoring the pump flow.If pump flow does not increase as the valve is opened, shut the engine off and determine what is preventing the pump from upstroking.
Start the engine.
Place the machine controls at the following settings: engine speed dial "10" and AEC switch OFF. Refer to Testing and Adjusting, "Engine Performance - Test (Engine Speed)" for engine rpm settings.
Increase the hydraulic oil temperature to 55° 5°C (131° 9°F).
Move the joystick for the boom to the full BOOM RAISE position. Hold the joystick for the boom in this position.
Illustration 6 g01867634
Portable hydraulic tester (flow meter)
(21) Portable hydraulic tester (flow meter)
(31) Valve
Turn valve (31) on portable hydraulic tester (21) clockwise. Record pump flow at each of the following pressures in Table 3. Use pressure gauge at pressure tap (29) and pressure tap (30) to monitor delivery pressure from both pumps.
Return the joystick for the boom