HARNESS AS-MOTOR 2917551 - Caterpillar

Introduction
This Special Instruction outlines the procedure for installation of the shield and seal on the exhaust manifold of certain C9, C13, C15and C18 Machine and Commercial engines.Required Parts
Table 1
Model Qty Part Number Part Description
C9 2 380-8550 Shield As
2 379-8572 Seal As
C13 2 380-8549 Shield As
2 379-8574 Seal As
C15
C18 2 380-8548 Shield As
2 379-8574 Seal As Installation Procedure
Improper installation of the packing material can result in a manifold fire.
Remove the current shield and packing material from the exhaust manifold and discard.
Do not modify the seal in any way. The modification could result in a manifold fire.
Illustration 1 g03325992
Install seal (1) into one half of clamshell (2).
Illustration 2 g03325998
Fit the lower portion of the seal in contact with center manifold section (4). Be sure that edge (3) fits inside and against center section (4).
Illustration 3 g03326012
Use tape in order to hold the seal in place for installation. The use of anything other than tape may prevent the clamp from properly seating.
Illustration 4 g03326040
Place upper clamshell (6) half in place.Note: Orienting the clamshell horizontally as shown in the picture is recommended.
Illustration 5 g03326046
Install clamp (7) onto clamshell. Tighten the clamp until both halves of the clamshell contact.
Tighten the clamp that secures the shield.Note: Ensure that no seal material is visible after assembly.
Torque the worm gear to: 10 N m (7 lb ft).
Torque the t-bolt clamp to 8 N m (6 lb ft).