HARNESS ASSEMBLY-FRONT 3006440 - Caterpillar

Remove two bolts (41), the washers, and the clips.
Illustration 25 g00846764
Bottom View
Remove bolt (42), the washer, and the clip.
Disconnect electrical connector (43) .Note: Place the harness on top of the engine.
Illustration 26 g00846767
Disconnect tube assembly (44) .
Remove bolt (47), the washer, and the clip.
Remove two bolts (46), the washers, and the spacers from the bottom of the oil pan. Place bracket assembly (45) aside.
Illustration 27 g00846771
Disconnect hose assembly (48) .
Illustration 28 g00846773
Disconnect hose assembly (49) .
Illustration 29 g00846777
Loosen two hose clamps (50) .
Disconnect tube assembly (51) .
Illustration 30 g00846779
Bottom View
Disconnect hose assembly (52) .
Illustration 31 g00846781
Remove four bolts (53) and the washers.
Illustration 32 g00846783
Use suitable cribbing and place automatic greasing assembly (54) aside, as shown.
Illustration 33 g00846791
Disconnect hose assembly (55) from air conditioner compressor (56) .
Illustration 34 g00846793
Remove bolt (57), the washer, and the clip.
Remove bolt (59), the washer, and the clip. Place hose assembly (58) aside.
Illustration 35 g00846817
Install Tooling (B) on the torque converter housing in order to support the transmission when the engine is removed.
Support Tooling (C) with suitable cribbing. Attach Tooling (C) to Tooling (B), as shown.
Illustration 36 g00846820
Attach Tooling (D) to the lifting points on the engine, as shown. Attach a suitable hoist to Tooling (D) .
Illustration 37 g00846830
Remove engine mounting bolt (60). Repeat this procedure for the opposite side.
Illustration 38 g00846824
Remove ten bolts (61) and the washers in order to separate the engine from the transmission.
Use the hoist in order to remove the engine. The weight of the engine is 1000 kg (2200 lb).Note: Adjust the lever puller hoist in order to keep the engine level.