HARNESS AS 3068464 - Caterpillar

Illustration 8 g00690482
Improper assembly of parts that are spring loaded can cause bodily injury.To prevent possible injury, follow the established assembly procedure and wear protective equipment.
Install spacer (28) and bolts (27) to the steering pilot valve. Tighten bolts (27) to a torque of 13 1.5 N m (115 13 lb in).
Illustration 9 g00690430
Install clamp (24) for the boot.
Install bracket (26).
Apply Tooling (A) to bolt (25). Install bolt (25). Tighten bolt (25) to a torque of 25 3 N m (19 2 lb ft).
Illustration 10 g01237287
Install handle (23) and dowel (22) to the steering pilot valve.
Install connecting links (21).
Illustration 11 g00690391
Install boot (20) to the steering pilot valve (7).
Illustration 12 g00690390
Install base (19) to the steering pilot valve. Install set screw (18). Repeat this procedure for the opposite side.
Illustration 13 g00690387
Install locknut (17). Tighten locknut (17) to a torque of 100 20 N m (75 15 lb ft).
Illustration 14 g00690386
Install eight wires to harness assembly (15).
Install wedge (16) to the harness assembly (15).
Illustration 15 g00690381
Install the harness assemblies.
Install nuts (14) and the washers.
Install tie straps (13).
Illustration 16 g00690339
Install rocker switch (12).
Install bolts (11).
Install ground wire and bolt (10).
Illustration 17 g00690337
Illustration 18 g01237270
Install cover (9) to the rocker switch.
Install screws (8) to the rocker switch assembly.
Illustration 19 g00690332
Install STIC steering control lever (6) to the steering pilot valve (7). Install screws (5). Repeat this procedure for the opposite side.
Illustration 20 g00690331
Install housing (4) and two screws (3). Tighten screws (3) to a torque of 6 1 N m (53 9 lb in).
Illustration 21 g00690330
Install cover (2) and two screws (1). Tighten screws (1) to a torque of 6 1 N m (53 9 lb in). End By:
Install the STIC control. Refer to Disassembly and Assembly, "STIC Control and Pilot Valve (Steering) - Install".