HARNESS AS-TRANSMISSION 3082435 - Caterpillar

Stabilizer auto up feature is operated on an engine speed base timer. Make sure stabilizers are raised completely before moving the machine. Failure to do so could result in injury or death.
Illustration 1 g06277314
The grousers are facing downward.
Illustration 2 g06277319
The stabilizer street pad is facing downward.
A flip-over stabilizer pad gives the operator the advantage of having one pad that can be used on either soil or pavement. The stabilizer pad is equipped with a pin and a retention pin.
Illustration 3 g06327025Note: The operator seat should be facing the rear of the machine when deploying stabilizersMove lever (1) to control the stabilizer on the left side of the machine.Move lever (2) to control the stabilizer on the right side of the machine.
STABILIZER DOWN (3) - Move the lever to this position to lower the stabilizer. The lever in this position will raise the rear of the machine.Hold (4) - Release the lever from the STABILIZER DOWN position or from the STABILIZER UP position to stop the stabilizer movement.
STABILIZER UP (5) - Move the lever to this position to raise the stabilizer. The lever in this position will lower the machine.Auto Up Mode (6) - Move the lever to this position to raise the stabilizer. The lever will go back to the HOLD position, but the hydraulic system will automatically move the stabilizers to the fully up positionNote: Be careful when you raise the stabilizers. The stabilizers can be the only restraint that is preventing the machine from falling into the area that is being excavated. When you operate on a slope, engage the parking brake before you raise the stabilizers.Note: When the stabilizers are not in the fully raised position, the backhoe may contact the stabilizers. This contact could damage the machine.Note: Ensure that the machine transmission is in NEUTRAL position before lowering the stabilizers.Before you operate the backhoe, use the stabilizers to lift the machine and use the stabilizers to level the machine.