HARNESS AS-CHASSIS 3200974 - Caterpillar

Pressurized System!Hydraulic accumulators contain gas and oil under high pressure. DO NOT disconnect lines or disassemble any component of a pressurized accumulator. All gas pre-charge must be removed from the accumulator as instructed by the service manual before servicing the accumulator or any accumulator component.Failure to follow the instructions and warnings could result in personal injury or death.Only use dry nitrogen gas to recharge accumulators. See your Cat dealer for special equipment and detailed information for accumulator service and charging.
Refer to Operation and Maintenance Manual, "Equipment Lowering with Engine Stopped" for further information.Jump Start Cables (15)This safety message is located inside the left front compartment.
Illustration 17 g01370909
Explosion Hazard! Improper jumper cable connections can cause an explosion resulting in serious injury or death. Batteries may be located in separate compartments. Refer to the Operation and Maintenance Manual for the correct jump starting procedure.
Refer to Operation and Maintenance Manual, "Engine Starting with Jump Start Cables" for further information.Crushing Hazard (16)This safety message is located on both sides of the back end of the machine.
Illustration 18 g01374060
Machine swings. Stay back. Crushing hazard could cause serious injury or death.
Crushing Hazard (17)This safety message is located on both sides of the stick.
Illustration 19 g01385579
A crushing hazard exists when the stick and boom are in motion and when the machine is being used in object handling applications. Failure to stay clear of the stick and boom when the machine is in operation can result in personal injury or death. Stay clear of the stick and boom when the machine is in operation.
High Pressure Cylinder (18)This safety message is located on the track adjuster.
Illustration 20 g01371642
High Pressure Cylinder. Do not remove any parts from the cylinder until all of the pressure has been relieved. This will prevent possible personal injury or death.
Refer to Operation and Maintenance Manual , "Track Adjustment - Adjust" for the proper service procedure.Relieve Hydraulic Tank Pressure (19)This safety message is located on top of the hydraulic tank.
Illustration 21 g01371640
HYDRAULIC TANKRELIEVE TANK PRESSURE WITH ENGINE OFF BY REMOVING CAP SLOWLY TO PREVENT BURNS FROM HOT OIL.
Hot Surface (20)This safety message is located in two locations on the engine hood.
Illustration 22 g01372256
Hot parts or hot components can cause burns or personal injury. Do not allow hot parts or components to contact your skin. Use protective clothing or protective equipment to protect your skin.