HARNESS AS-TRANSMISSION 3240685 - Caterpillar

Table 1
Effective Serial Numbers
S/N:M6A01016-UP
S/N:M6B01011-UP
S/N:P6L01003-UP
S/N:P5P01003-UP
S/N:WYB01924-UP
S/N:WYC02006-UP
S/N:BXR01780-UP
S/N:3A900137-UP
S/N:Y3A00137-UP
S/N:KWT00135-UP
S/N:R1X00114-UP Note: Only recommended to change or remove oil dowels at engine PCR or anytime where the block will be thoroughly cleaned.Note: Field installation is not recommended.Installation Procedure
Illustration 1 g06051808
Use caps or plugs to prevent dirt or containments to get into oil system before installing new oil feed dowels.
Illustration 2 g06051829
Insert to the top of alignment shoulder.
Use plastic dead blow hammer to tap in.
Tap in until the bottom of the cap is flush with the block. Do not over drive and damage dowel or block.
If the dowel cap is removed for any reason, torque the cap to 2 1 N m (17 9 lb in).Removal Procedure
Note: Cleanliness is an important factor. Before the removal procedure, clean the exterior of the component thoroughly. Cleaning the exterior will help to prevent dirt from entering the internal mechanism.
Clean and vacuum thoroughly around the dowel.
Illustration 3 g06051749
Use proper screw driver and technique to avoid damage.
Illustration 4 g06051756
Parts with burrs or damage must be replaced.
Illustration 5 g06051763
Use a slide hammer or bolt/nut M10 X 1.5 and spacer as shown in Illustration 5.