HARNESS AS-SENSOR 3391553 - Caterpillar

Illustration 1 g03598546
Top view
Table 1
Item Qty Part Specification Description
1 2 260-8719 Pin Diameter is 44.78 0.05 mm (1.763 0.002 inch).
C - - Minimum gap under retainer is 0.03 mm (0.001 inch).
Illustration 2 g06332079
Table 2
Item Qty Part Specification Description
2 - 3B-4640 Cotter Pin Torque to 220 30 N m (162 22 lb ft) plus torque required to align cotter slot.
4 1 488-7215 Steering Link Gp Orient bolts (3) and (5) as shown and tighten nuts on clamps to 75 7 N m (55 5 lb ft).
6 4 257-9799 Pin Diameter is 50.749 0.005 mm (1.9980 0.0002 inch).
7 2 295-0775 Pin As Diameter is 50.760 0.025 mm (1.9984 0.0010 inch).
H - - Gap between washer and ring is 1.6 0.5 mm (0.06 0.02 inch).
8 - Nut Fill with 5P-1228 Oil to the level that is indicated on the outer cover.
Torque to 30 10 N m (266 89 lb in).
Illustration 3 g03598677
260-8703 Arm As
Table 3
Item Qty Part Specification Description
10 2 146-1842 Bushing Bore before assembly is 51.016 0.025 mm (2.0085 0.0010 inch).
Assemble bushing to line up grease groove with hole in lean arm.
Illustration 4 g03598717
260-8699 Front Axle Gp
Table 4
Item Qty Part Specification Description
11 4 2G-8793 Bushing Bore before assembly is 51.016 0.025 mm (2.0085 0.0010 inch).
Installation depth is 7.2 0.5 mm (0.28 0.02 inch).
12 2 131-4428 Bushing Bore before assembly is 51.016 0.025 mm (2.0085 0.0010 inch).
Installation depth is 7.2 0.5 mm (0.28 0.02 inch).
Install the bushing so that the part number is visible from the outside of the assembly.
13 2 2D-8652 Bearing Bore before assembly is 31.75 mm (1.250 inch).
Installation depth is 1.2 0.5 mm (0.05 0.02 inch).