HARNESS AS-SENSOR 3393562 - Caterpillar

(1) Torque for gage ... 45 6 N m (33 4 lb ft)(2) Torque for eight bolts ... 475 60 N m (350 45 lb ft)(3) Torque for 12 bolts ... 300 40 N m (220 30 lb ft)(4) Outside diameter of new trunnion ... 126.80 0.08 mm (4.992 .003 in) Inside diameter of new bearing ... 127.79 0.13 mm (5.031 .005 in)(5) Inside diameter of new support ... 139.75 0.05 mm (5.502 .002 in) Outside diameter of new bearing ... 140.23 .13 mm (5.521 .005 in)(6) See Axle Housing Assembly And Axle Bearing Preload Adjustment(7) Torque for 52 bolts ... 300 40 N m (220 30 lb ft)(8) Inside diameter of new support ... 225.00 0.05 mm (8.858 .002 in) Outside diameter of new bearing ... 225.48 0.08 mm (8.877 .003 in)(9) Outside diameter of new housing ... 209.55 0.08 mm (8.250 .003 in) Inside diameter of new bearing ... 210.46 0.22 mm (8.286 .009 in)(10) Torque for six bolts ... 270 40 N m (200 30 lb ft)(11) Torque for four bolts ... 570 80 N m (420 60 lb ft)(12) Torque for 12 bolts ... 300 40 N m (220 30 lb ft)(13) Torque for eight bolts ... 475 60 N m (350 45 lb ft)(14) Rubber toric seals and all surfaces in contact with them must be clean and dry at assembly. Put a thin layer of oil on the surfaces of the metal seals that are in contact just before installation. Seal must be assembled square with the bore and the toric seal must not be bulged or twisted.(15) Torque for bleeder screw ... 11 4 N m (8 3 lb ft)(16) Torque for pressure relief screw ... 13 4 N m (10 3 lb ft)