HARNESS AS-WIRING 3541184 - Caterpillar

Installation Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     5P-0327     Crowfoot Wrench     1    
B     180-0186     Removal Tool     1    
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g01025556
Position drive gear (8) on the unit injector hydraulic pump. Install the bolt on the unit injector hydraulic pump. Tighten the bolt to a torque of 110 14 N m (81 10 lb ft).
Lubricate O-ring seal (7) with clean engine oil. Install the O-ring seal on the unit injector hydraulic pump.
Illustration 2 g01025536
Position unit injector hydraulic pump (5) on the front housing. Install bolts (6) and tighten bolts (6) to a torque of 28 7 N m (20 5 lb ft).Note: If the engine is equipped with a tube assembly then proceed to Step 4. If the engine is equipped with a hose assembly then go to Step 6.
Use Tooling (A) to install tube assembly (1) and tube assembly (2) .Note: If the engine is equipped with a hose assembly, use Tooling (B). Connect fitting (4) .
Connect harness assembly (3) .
Use Tooling (A) to install tube assembly (2) .