HARNESS AS-ENGINE 3570445 - Caterpillar

Illustration 1 g00915930
IQANtalk Connection
Connect a serial cable between your PC and the IQAN system of your machine. The IQANtalk connection is a 9-pin connector that is located behind the rear access panel in the cab.
Turn the engine start switch to the ON position.
Illustration 2 g00915955
Select "Get" from "System" menu (1) or select icon (2) in order to receive the current parameters from your IQAN system.
Illustration 3 g00915956
Select "Hydrostat" from "Function" menu (3) .
Change the value for the "Trim transm." (4) to a value of "1".
Select "Send F2" (5) or press "F5" in order to send the current parameters for the "Hydrostat" option. This will allow the "XMSN pump" option and the "XMSN motor" in the "Maintenance" menu to be adjusted on your IQAN display.
At the main menu of the IQAN display, press the menu key and then press the right arrow key. The following window will appear.
Illustration 4 g00916015
Press the function key beside the "Maintenance" option. The following window will appear.
Illustration 5 g00937280
(5) "XMSN pump". (6) "XMSN motor"."XMSN Pump"
You can adjust the minimum current and the maximum current to the power train pump.
Illustration 6 g00916018
Press the function key beside the "XMSN pump" option.
Illustration 7 g00916029
"Engine Speed" - This parameter shows the engine speed in revolution per minute (RPM)."Output" - This parameter shows the output current that flows from the IQAN to the power train pump."PT Motor" - This parameter shows the speed of the power train motor in revolution per minute (RPM)."Max forward" - This is the maximum current setting for the power train pump in the forward direction. When the accelerator pedal reaches the end of travel and the maximum speed potentiometer is set to 100%, the maximum current will flow from the IQAN. The maximum current should be adjusted so that the maximum speed of the machine corresponds to maximum travel of the accelerator pedal. If the maximum current is