HARNESS AS-ENGINE 3585517 - Caterpillar

start by:a) remove stick 1. Remove seal (1) from each side of bearing (2) on each side of the boom. 2. Use tooling (A) to remove the bearing from each side of the boom.3. Lower the temperature of the bearings. Use tooling (A) to pull the bearing into each side of the boom. Pull the bearings into the boom until they are .44 in. (11.2 mm) below the inside surface of the boom. 4. Install lip type seal on each side of each bearing with tooling (B). Install the seals with the seal lip away from the bearing. Put a thin layer of 5P960 Multipurpose Type Grease on the seal lips and bearing surfaces.end by:a) install stickRemove And Install Stick Cylinder Bearings In The Boom
start by:a) remove stick cylinder 1. Use tooling (A) as shown to remove the two bearings from the boom.2. Lower the temperature of the bearings. Use tooling (A) as shown to pull the two bearings into the boom. The bearings must not extend beyond the inside surface of the bore. Put a thin layer of 5P960 Multipurpose Type Grease on the bearings surface.end by:a) install stick cylinderRemove And Install Bucket Cylinder Bearings In The Boom
start by:a) remove bucket cylinders The bucket cylinder bearings in the boom must be damaged to be removed. Remove only if necessary. 1. Remove bearing (1) from each side of the boom. 2. Lower the temperature of the bearings. Use tooling (A) to pull the bearing into each side of the boom. The installed bearings must be even with the outside surface of the boom. Put a thin layer of 5P960 Multipurpose Type Grease on the bearings surface.end by:a) install bucket cylinders.Remove And Install Master Cylinder Bearings In The Boom
start by:a) remove master cylinder 1. Use tooling (A) to remove the two bearings from the boom.2. Lower the temperature of the bearings. Use tooling (A) to pull the bearing into the boom. The installed bearing must not extend beyond inside surface of the bores. Put a thin layer of 5P960 Multipurpose Type Grease on the bearings.end by:a) install master cylinderRemove And Install Frame Bearings In The Boom
start by:a) remove boom 1. Remove seal (1) from each side of bearing (2) on each side of the boom. 2. Use tooling (A) to remove the bearing from each side of the boom.3. Lower the temperature of the bearings. Use tooling (A) to pull the bearings into the boom. Pull the bearings into the boom until they are .40 .02 in. (10.2 0.5 mm) below the inside surface of the boom. 4. Install the lip type seal on each side of the bearing with tooling (B). Install the seals with the seal lip away from the bearing. Put a thin layer of 5P960 Multipurpose Type Grease on the seal lip and bearing surface.end by:a) install boom