HARNESS AS-CONTROL 3732789 - Caterpillar

Note: Before performing any operation or maintenance procedures, ensure that the Safety Information, warnings, and instructions are read and understood.To determine the maintenance intervals, use fuel consumption, service hours, or calendar time, whichever occurs first. Experience has shown that maintenance intervals are most accurately scheduled on the basis of fuel consumption.Before each consecutive interval is performed, all of the maintenance items from the previous interval must also be performed.When Required
Battery - Replace
Battery or Battery Cable - Disconnect
Fuel Control Linkage - Check/Lubricate
Fuel System - Prime
Daily
Cooling System Coolant Level - Check
Engine Oil Level - Check
Marine Transmission Oil Level - Check
Walk-Around Inspection
First 700 L (185 US gal) of Fuel or First 25 to 50 Service Hours
Alternator Belt - Inspect/Adjust/Replace
Engine Valve Lash - Inspect/Adjust
Every 5700 L (1500 US gal) of Fuel or 400 Service Hours or 1 Year
Alternator Belt - Inspect/Adjust/Replace
Auxiliary Water Pump (Rubber Impeller) - Inspect
Battery Electrolyte Level - Check
Cooling System Supplemental Coolant Additive (SCA) - Test/Add
Crankshaft Vibration Damper - Inspect
Engine Air Cleaner Element - Clean/Replace
Engine Oil Sample - Obtain
Engine Oil and Filter - Change
Fuel System Secondary Filter - Replace
Fuel Tank Water and Sediment - Drain
Fuel Transfer Pump Strainer - Clean
Heat Exchanger - Inspect
Hoses and Clamps - Inspect/Replace
Sea Water Strainer - Clean/Inspect
Every 11 400 L (3000 US gal) of Fuel or 800 Service Hours
Aftercooler Core - Clean/Test
Engine Crankcase Breather - Clean/Replace
Every 14 400 L (3750 US gal) of Fuel or 1000 Service Hours
Marine Transmission Oil Cooler - Clean/Inspect
Every 28 500 L (7500 US gal) of Fuel or 2000 Service Hours or 1 Year
Alternator - Inspect
Starting Motor - Inspect
Turbocharger - Inspect
Every 28 500 L (7500 US gal) of Fuel or 2000 Service Hours or 2 Years
Cooling System Coolant (DEAC) - Change
Cooling System Water Temperature Regulator - Replace
Engine Valve Lash - Inspect/Adjust
Fuel Injection Nozzles - Test/Exchange
Water Pump - Inspect
Every 43 200 L (11 250 US gal) of Fuel or 3000 Service Hours or 2 Years
Cooling System Coolant Extender (ELC) - Add
Every 87 000 L (23 000 US gal) of Fuel or 6000 Service Hours
Cooling System Coolant (ELC) - Change
Overhaul Considerations