HARNESS AS- 3857400 - Caterpillar

Floor Mount
Mounting Information
Inspect the location for the installation.
Make sure that the floor meets the load requirements in order to support the Generator Set Start Module.
Make sure that there is sufficient space between the Generator Set Start Module and any obstructions.Note: The Generator Set Start Module must be securely mounted to the floor. Use suitable hardware (1/2 inch) for anchoring.Wall Mount
Mounting Information
Inspect the location for the installation.
Make sure that the location (Wall Mount) can safely support the weight of the Generator Set Start Module.
Make sure that the wall can accommodate the necessary mounting hardware.
Make sure that sufficient clearance for the door is maintained.
If the hardware for mounting the unit on the floor is attached, remove the hardware.The Generator Set Start Module has four mounting holes for mounting on a wall. These mounting holes are in the flanges that are located on the back of the cabinet. These holes accommodate 1/2 inch mounting hardware. There must be at least 304.80 mm (12.00 inch) of clearance on top and 406.40 mm (16.00 inch) at the bottom of the cabinet.The enclosure should be mounted on two horizontal channels. Use 1/2 inch steel bolts and appropriate nuts for the channel.