HARNESS AS-SENSOR 3884017 - Caterpillar

Illustration 1 g00751947
Typical example
Note: During assembly, inspect the following components for any foreign materials: the front face of the flywheel housing, the two sides of the flywheel housing gasket and the rear face of the cylinder block. These components must be free of the following substances: oil, fuel, water, gasket adhesive, assembly compounds and any other foreign material. Apply Loctite 587 Blue RTV Silicone to the space between the cylinder block, the flywheel housing, and the oil pan. Install the oil pan gasket and the oil pan. (1) Tighten the bolts, as follows:
Install washers to bolts and in a numerical sequence, tighten bolt 1 through bolt 9. Torque for the nine bolts ... 100 20 N m (75 15 lb ft)
Install washers to bolts and in a numerical sequence, tighten bolt 10 through bolt 14. Torque for the five bolts ... 40 10 N m (30 7 lb ft)
Install washers and spacers to bolts and in a numerical sequence, tighten bolt 15 through bolt 24. Torque for the ten bolts ... 40 10 N m (30 7 lb ft)
In a numerical sequence, from bolt 1 through bolt 9, remove one bolt at a time. Apply Loctite 7649 and then apply Loctite 263 to the threads of the bolts prior to assembly. Torque for the bolts ... 135 20 N m (100 15 lb ft)
In a numerical sequence, from bolt 10 through bolt 24, remove one bolt at a time. Apply Loctite 7649 and then apply Loctite 263 to the threads of the bolts prior to assembly. Torque for the 15 bolts ... 55 10 N m (40 7 lb ft)