HARNESS AS-VALVE 3953148 - Caterpillar

Table 1
Effective Serial Number
S/N:C7P00314-UP
S/N:JTF23673-UP
S/N:TEF00621-UP
S/N:KPM00239-UP Rework Procedure
Disconnect the wiring harness from the HEUI pump, main injector connector, atmosphere sensor, rail pressure sensor, and ECM.
Remove the valve cover.
Remove the valve cover base.
Remove the rocker arm.
Inspect the pushrods for damage.
If exhaust pushrods 1 and 2 are found damaged, perform the following steps:
Remove the compressor.
Remove the speed sensors but do not disconnect harness.
Remove the HEUI pump.
Illustration 1 g06037466
Remove the side cover.
Illustration 2 g06037480
Install a rag over the camshaft to prevent any debris contamination.
If the exhaust pushrods 3, 4, 5 and 6 are found damaged, perform the following steps:
Remove the ECM.
Illustration 3 g06037466
Remove the side covers.
Illustration 4 g06037480
Install a rag over the camshaft to prevent any debris contamination.
Illustration 5 g06037484
(1) File
Illustration 6 g06037504
File down the corner of the block to remove approximately (0.2 mm).
Illustration 7 g06037512
Illustration 8 g06037515
Flush with oil on the reworked area and wipe with a clean rag to remove debris that may still be in the rework area.
Install the side covers.
Install a new pushrod to replace any that were found damaged.
Install the rocker arm assembly.
Verify that the valve lash is set to the specifications.
During the valve lash verification, visually verify clearance between the pushrod and the block.
Visually verify that pushrods are seated correctly on both ends.
Install the valve cover base.
Install the valve cover.
Reinstall all the components that were removed after steps 6 and 7.
Touch up the fastener hardware with paint as necessary.