HARNESS AS-FRONT 4258723 - Caterpillar

The flywheels should be at zero (0) RPM when performing this calibration.
Perform the Flywheel A calibrations in the order that the calibrations appear on the Calibrate pull-down menu. Perform the following steps in order to calibrate the flywheel load cell.
Place the keyswitch of the Flywheel cabinet in the "Spindown/Offline" position.
Connect a PC to the UPS according to the instructions in Testing and Adjusting, "Personal Computer to UPS Connection".
Place the system in the Bypass mode. Refer to Testing and Adjusting, "Transfer to Bypass Mode".
Illustration 1 g01321408
Calibrate Load Cell
Open the "Calibrate" drop-down menu in UPS View.
Select "Load Cell" from the "Calibrate" drop-down menu.The window which is shown in illustration 2 appears.
Illustration 2 g01321410
A: Load Cell - Minimum Bottom Bearing Force
Click the "Use Defaults" button.
Disconnect the wiring harness from "J4" of the interface board connector for Flywheel A.
Illustration 3 g01321411
Flywheel Interface Board With a Jumper in J4 (1) MIN/MAX Jumper
Plug the "MIN" jumper connector (3) into "J4" of the interface board connector for Flywheel A.
Illustration 4 g01321439
View of "Min/Max Jumpers" for new FWI PWAS (2) 268-0058 Cable Assembly (MAX) (3) 268-0057 Cable Assembly (MIN)
Ensure that the "Minimum" button is highlighted in the "Calibration of a Channel" window.The value for the minimum setting should be close to zero (0).
Click the "OK" button.
Illustration 5 g01321414
A: Load Cell - Maximum Bottom Bearing Force
Click the "Maximum" button.
Change the jumper in J4 from the "MIN" jumper (3) to the "MAX" jumper (2). The load cell reading should be approximately 1333 lb.
Click the "OK" button.
Click the "View Status" button.
Illustration 6 g01321416
Bottom Bearing Force Calibration Status
Remove the jumper and reconnect the harness.
Click the "Save" button.
Repeat for Flywheel B.