HARNESS AS-ENGINE 4287383 - Caterpillar

VIMS Connector (17)
Illustration 23 g02560317
(53) VIMS Connector
(54) 12 Volt Socket Additional software is available to download machine information from the VIMS Connector. This software can also be used to download and upload information to the Payload Control System. Consult your Cat dealer for more information about the VIMS software.Implement Controls (11)
Joystick Controls (If Equipped)
Illustration 24 g03016801
Joystick Work Tool Controls (If Equipped)
(101) Pusher Control
(103) Rotate Grapple
(104) Horn
(110) Tilt
(116) Grapple-Tilt In/out
(117) Joystick
Illustration 25 g03018157
(1) Raise Lift Arm
(2) Grapple Close
(3) Lower Lift Arm
(4) Grapple Open
(5) Tilt Arm Front
(6) Tilt Arm Rear
(7) Tilt Out
(8) Tilt In
Illustration 26 g03018203
(9) Pusher Auto Raise/Loser
(10) Rotate Grapple Clockwise
(11) Rotate Grapple Counter Clockwise
Illustration 27 g03016803
Right-hand console fore/aft adjustment. Push the knob in order to slide the console.
Refer to the "Operation and Maintenance Manual" for the grapple for more information.Machine Security System (If Equipped)
This machine is equipped with a Caterpillar Machine Security System (MSS) and may not start under certain conditions. Read the following information and know your machine's settings. Your Caterpillar dealer can identify your machine settings.
Machine Security System (MSS) - Machines that are equipped with a Cat Machine Security System (MSS) can be identified by a decal in the operator station. MSS is designed to prevent theft of the machine or unauthorized operation.Basic Operation
MSS may be programmed to read a standard Cat key or an electronic key. The electronic key contains an electronic chip within the plastic housing for the key. Each key emits a unique signal to the MSS. The keys can be identified by a gray housing or a yellow housing. MSS can have programmed settings to require an electronic key or a standard Cat key for starting during certain periods of time.When the key start switch of the machine is turned to the ON position, the ECM will read the unique ID. The ECM will then compare this ID to the list of authorized keys. The following table tells the operator the status for starting the machine. The status light is located near the key start switch.
Table 1
Green light The machine will start.
Red light The key is not authorized. Note: MSS will not shut down the machine after the machine has started. Security Management
The MSS allows you to program the system to automatically activate at different time periods with different keys. The MSS can also be programmed to reject a specific electronic key after a selected date and time. When you turn the key to the OFF position and the MSS is active, you have 30 seconds in order to restart the machine with an unauthorized key. Also if the machine stalls, there is a 30 second interval for restarting the machine. This 30 second interval is counted from the time of turning the key to the OFF position.Note: Know your machine settings because the use of an electronic key is no guarantee that the machine can be restarted.An expiration date can be set for each electronic key that is contained in the list of keys for the machine. The key will no longer start the machine when