HARNESS AS-WIRING 4371314 - Caterpillar

Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Cylinders equipped with lock valves can remain pressurized for very long periods of time, even with the hoses removed.Failure to relieve pressure before removing a lock valve or disassembling a cylinder can result in personal injury or death.Ensure all pressure is relieved before removing a lock valve or disassembling a cylinder.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the machine. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide"for tools and supplies to collect and contain fluids in Caterpillar machines.Dispose of all fluids according to local regulations.
Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
Illustration 1 g06044462
Remove retaining plates (1). Use suitable lifting device to remove shroud (2). The weight of shroud (2) is approximately 102 kg (225 lb)
Illustration 2 g06047468
Remove bolts (3) and cover (4).
Illustration 3 g06047471
Disconnect harness assembly (5).
Disconnect hose assemblies (6).
Illustration 4 g06047533
Remove snap ring (7) and retaining pin (8). Repeat procedure for the opposite side of the machine.
Use suitable lifting device to remove steering cylinder (9). The weight of steering cylinder (9) is approximately 85 kg (187 lb)
Illustration 5 g06047537Note: Some items have been removed from the machine for photo clarity.
Use suitable lifting device to support conveyor first stage (13). The weight of conveyor first stage is approximately 680 kg (1500 lb)
Remove bolts (11) and bolts (12).
Remove retaining pin (10).
Repeat Step 8 and Step 9 for the opposite side of the conveyor first stage.
Illustration 6 g06047555
Disconnect hose assembly (17), hose assembly (18) and hose assembly (19).
Illustration 7 g06047564
Remove bolts 20. Place block assembly (19) out of the way. Repeat process for the opposite side of the machine.
Illustration 8 g06047569
Illustration 9 g06048183
Use Tooling (B) and a suitable lifting device to support first stage conveyor (13). The weight of first stage conveyor (13) is approximately 680 kg (1500 lb)
Remove cotter pin (21) and clevis pin (22). Move link assembly (23) out of the way. Repeat process for the opposite side of the machine.
Lower first stage conveyor onto Tooling (A) and remove from machine.Installation Procedure
Install first stage conveyor assembly (13) in the reverse order of removal.