HARNESS AS-ENGINE 4715192 - Caterpillar

Table 6
Temperature Compensation    
Temperature In The Service Shop        
Outside Temperature        
Temperature Difference        
Added Length For Temperature Compensation (1)        
( 1 ) If the temperature difference is greater than 11°C (20°F), multiply the temperature difference by 2.54 mm (0.10 inch). Then, divide this amount by 5.5°C (10°F).
Table 7
Corrected Reference Lines For The Nitrogen Charging Procedure    
       
Table 8
Rear Suspension Cylinders    
    Left     Right    
Length Of Chrome (1)            
Length Of Clean Chrome (2)            
( 1 ) This is the dimension between the centerline of the bottom mounting pin and the bottom of the cylinder housing.
( 2 ) During operation, the wiper seals wiped off this chrome.Charging The Front Suspension Cylinder
Table 9
Model Of The Machine         Date        
Serial Number         Service Meter Hours        
Component Damage        
Table 10
Dimensions For Charging Procedure    
Reference Line For The Oil Charging Procedure    
25.4 mm (1.00 inch)    
Height Of The FT1680 Gauge Block (1)    
170.0 mm (6.69 inch)    
Pressure Setting For The Oil Charging Procedure    
860 kPa (125 psi)    
Initial Pressure Setting For The Nitrogen Charging Procedure    
4150 kPa (600 psi)    
Final Pressure Setting For The Nitrogen Charging Procedure    
2400 kPa (350 psi)    
( 1 ) Additional length may be needed for temperature compensation. See Table 11.
Table 11
Temperature Compensation    
Temperature In The Service Shop        
Outside Temperature        
Temperature Difference        
Shim Pack Thickness For Temperature Compensation (1)        
( 1 ) If the temperature difference is greater than 11°C (20°F), multiply the temperature difference by 6.4 mm (0.25 inch). Then, divide this amount by 5.5°C (10°F).
Table 12
Front Suspension Cylinders    
    Left     Right    
Length Of Chrome (1)            
Length Of Clean Chrome (2)            
( 1 ) This is the dimension between the top of the axle and the bottom of the cylinder housing.
( 2 ) During operation, the wiper seals wiped off this chrome.Take the measurements for Table 12 after the gauge blocks have been removed.