HARNESS AS-CAB 4729813 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 2P-8250 Strap Wrench As 1
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Note: Put identification marks on all hoses, on all hose assemblies, on all wires, and on all tube assemblies for installation purposes. Plug all hose assemblies and all tube assemblies. This helps to prevent fluid loss, and this helps to keep contaminants from entering the system.
Turn the fuel supply valve to the OFF position.
Illustration 1 g00922347
Use Tooling (A) and remove fuel filters (1).
Illustration 2 g00922353
Remove bolts (2) and remove plate (3).
Illustration 3 g00922354
Disconnect tube assembly (6).
Support fuel filter base (5) and remove bolts (4). Installation Procedure
Illustration 4 g00922355
Check O-ring seals (7) for wear or damage. Replace O-ring seals, if necessary.
Illustration 5 g00922354
Install bolts (4). Connect tube assembly (6) onto fuel filter base (5).
Illustration 6 g00922353
Install plate (3). Install bolts (2).
Illustration 7 g00922347
Install fuel filters (1).
Turn the fuel supply valve to the ON position.