HARNESS AS 4757444 - Caterpillar

Linkage Adjustment Procedure:
1. With the governor in the OFF position, install lever (1) at angle (B). Adjust the length of rod (6) by turning rod ends (2) and (3) so lever (4) is at angle (C).2. Move lever (1) to HIGH IDLE position and adjust rod (8) by turning rod ends (7) and (9) so pedal (5) is at angle (A).3. Tighten nuts on rods (6) and (8).Angle A is ... 19°Angle B is ... 20 5°Angle C is ... 30 5°(955LTrack-Type Loader)
Linkage Adjustment Procedure:
1. Put the governor control (2) in the OFF position (approximately .47 in. (12 mm) from the end of slot in the guide.2. Adjust length of rod (3) so lever (5) is in the OFF position at the engine. Tighten nuts (4) on rod (3).3. With lever (5) in the center between discs, tighten nut (6) so force needed to move governor control lever (2) is 14.6 .9 lb. (65 4 N).Angle A for lever (1) and governor control (2) is ... 102 5°(950 Wheel Loader)
Linkage Adjustment Procedure:
1. With lever (1) in OFF position.2. Adjust rod (2) so lever (5) is at angle (C).3. Put pedal (4) in OFF position.4. Adjust length of rod (3) and install pin (6). Tighten locknuts on rods.Angle A is ... 37°Angle B is ... 6°Angle C is ... 11°(951 Track-Type Loader)
Linkage Adjustment Procedure:
1. Make an adjustment to rod (4) so length of rod is 28.20 .12 in. (716.3 3.0 mm) at center of pins. Tighten nuts on rod and install rod on machine.2. Put governor control lever (2) in the LOW IDLE position, approximately .25 in. (6.4 mm) from end of slot in guide.3. Adjust length of rod (5) so lever (6) at the engine is in the OFF position. Tighten nuts on rods.4. Tighten nut (3) so force on knob (1) is 13 1 lb. (58 4 N).Distance A is ... 28.20 .12 in.(716.3 3.0 mm)Angle B is ... 15°