HARNESS AS-WIRING 4857746 - Caterpillar

Two Speed Control
Depress the TWO SPEED CONTROL pedal to increase boom raise speed.The pedal can be used to increase the 235 STICK OUT speed.Release the pedal to resume normal speed.Swing and Stick Control - Backhoe
(H) HOLD(1) Stick moves out.(2) Stick moves out and house swings to the right.(3) House swings to the right.(4) Stick moves in and house swings to the right.(5) Stick moves in.(6) Stick moves in and house swings to the left.(7) House swings to the left.(8) Stick moves out and house swings to the left. The control will function in any position of the house. Swing speed is not decreased by using other hydraulic controls.Bucket and Boom Control - Backhoe
(H) HOLD.(1) Boom lowers.(2) Boom lowers and bucket opens.(3) Bucket opens.(4) Boom raises and bucket opens.(5) Boom raises.(6) Boom raises and bucket closes.(7) Bucket closes.(8) Boom lowers and bucket closes. The control will function in any position of the house.Swing and Stick Control - Front Shovel
(H) HOLD(1) Stick moves out.(2) Stick moves out and upper house swings to the right.(3) Upper house swings to the right.(4) Upper house swings to right and stick moves in.(5) Stick moves in.(6) Stick moves in and upper house swings to left.(7) Upper house swings to the left.(8) Upper house swings to the left and stick moves out. The control will function with the house in any position. Swing Speed is not decreased by using swing and stick control and other hydraulic controls simultaneously.Bucket and Boom Control - Front Shovel
(H) HOLD(1) Boom lowers.(2) Boom lowers and bucket dumps.(3) Bucket dumps.(4) Bucket dumps and boom raises.(5) Boom raises.(6) Boom raises and bucket racks back.(7) Bucket racks back.(8) Bucket racks back and boom lowers. The control will function with the house in any position.Bottom Dump Shovel Bucket Controls
Increased Pressure Switch Attachment (245 back-hoe machines only)
Move the switch to the right (ON) to allow hydraulic pressure in the boom raise circuit to increase from 31000 kPa (4500 psi) to 34500 kPa (5000 psi).This increases the lift capacity of the machine to permit lifting of extra heavy loads, like large sections of concrete pipe.With the switch on all hydraulic functions will operate at a slow speed.For maximum efficiency and to prevent stresses on components, move the switch to the left (OFF) for normal operation. Use the control only to lift extra heavy loads.Hydraulic and Anti-Travel Lock Lever
Place the HYDRAULIC AND ANTI-TRAVEL LOCK LEVER in the LOWER position before leaving the cab.
With the lock lever down, all hydraulic controls and travel pedals are INOPERABLE. With the lock lever up, all hydraulic controls and travel pedals are OPERABLE.Swing Lock Pin
ENGAGED - With the control lever forward the house will not swing. DISENGAGED - House will swing when the swing lever is in the rear position.
Engage pin only when house is aligned with track. Do not attempt to engage pin when house is rotating.Swing lock pin must be in ENGAGED position during transportation of machine.
Swing Brake Control
Brake RELEASED Brake APPLIEDSwing brake is used to prevent