HARNESS AS-CAB 4932543 - Caterpillar

Removal Procedure
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the machine. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide"for tools and supplies to collect and contain fluids in Caterpillar machines.Dispose of all fluids according to local regulations.
Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
Drain the hydraulic oil from the hydraulic oil tank into a suitable container for storage or disposal. Refer to Operation and Maintenance Manual for the correct procedure.
Turn the disconnect switch to the OFF position.
Illustration 1 g01427039
Remove bolts (2) and access panel (1). Use two people to remove access panel (1) .
Illustration 2 g01427040
Disconnect hose assemblies (4) and (3) from flow divider valve (5) .
Illustration 3 g01427047
Disconnect hose assemblies (6), (7), and (8) from flow divider valve (5) .
Illustration 4 g01427042
Disconnect harness assembly (14) .
Disconnect hose assemblies (9), (13, ), (12), and (10) from flow divider valve (5). Valve block (11) separates from flow divider valve (5) once hose assembly (10) is disconnected.
Remove bolts (15) and flow divider valve (5). Use two people to remove flow divider valve (5). The weight of flow divider valve (5) is approximately 36 kg (79 lb).