HARNESS ASSEM. 4Y5460 - Caterpillar

Illustration 1 g03595038Make sure that all of the messages are legible. Clean the messages or replace the messages if you cannot read the words. Replace the illustrations if the illustrations are not legible. When you clean the messages, use a cloth, water, and soap. Do not use solvent, gasoline, or other harsh chemicals to clean the messages. Solvents, gasoline, or harsh chemicals could loosen the adhesive that secures the message. Loose adhesive will allow the message to fall.Replace any message that is damaged, or missing. If a message is attached to a part that is replaced, install a message on the replacement part. Any Cat dealer can provide new messages.Data Privacy (1)
This message is located under the front of the canopy for an open platform with two posts, on the left rear post for an open platform with four posts and on the right rear cab post for a closed platform.
Illustration 2 g01418953The Product Link System is a satellite communication device that transmits information regarding the machine back to Caterpillar and Cat dealers and customers. All logged events and diagnostic codes that are available to the Caterpillar Electronic Technician (ET) on the CAT data link can be sent to the satellite. Information can also be sent to the Product Link System. The information is used to improve Caterpillar products and Caterpillar services.Refer to Operation and Maintenance Manual, "Product Link" for more information.Support Point (2)
This message is located on both sides of the machine.
Illustration 3 g01866913This location is recommended for supporting the machine or jacking up the machine.Fast Fill Fuel System (3) (If Equipped)
Illustration 4 g03595163This message is located near the fast fill connector at the back right of the fuel tank for machines equipped with this option. This system cannot accept a flow over 350 L/min (92 US gpm).