HARNESS AS-POWER 5053199 - Caterpillar

Rework Procedure
Do not operate or work on this product unless you have read and understood the instruction and warnings in the relevant Operation and Maintenance Manuals and relevant service literature. Failure to follow the instructions or heed the warnings could result in injury or death. Proper care is your responsibility.
Illustration 1 g06298192
Location of the MS1093 connector
Illustration 2 g06298193
Incorrect 2x4 pin buss bar
Illustration 3 g06298194
Correct 8-pin buss bar
Verify that the buss bar is two 4 pins and not an 8-pin buss bar. Refer to Illustration 2 and Illustration 3.
Illustration 4 g06298195
Original assembly
Illustration 5 g06298196
After repair
If the connector is 4-pin buss bar, remove the wire from socket 4 and install into socket 1.
Install a jumper harness from socket 4 to socket 8. Refer to Illustration 4 and Illustration 5.Note: For jumper harness, use 150 mm (5.9 inch) wire (BLK0-38-20) and two 303-4970 Connector Socket. This will bridge the two 4-pin buss bar to turn it into one 8-pin buss bar.