HARNESS AS-CEM 5088582 - Caterpillar

Procedure To Install A New 7W3200 Rear Crankshaft Seal And Wear Sleeve
Do not separate the seal and wear sleeve. Install them as a unit.
1. Clean and prepare the wear sleeve inside diameter and crankshaft outside diameter with 8M8060 Quick Cure Primer. Apply 9S3265 Retaining Compound to the crankshaft outside diameter and the wear sleeve inside diameter before the wear sleeve is installed on the crankshaft.2. Install the locator and bolts on the rear of the crankshaft. See Illustration.
Do not lubricate the seal lip and wear sleeve before installing on crankshaft.
3. Put the wear sleeve and seal in position on the locator with the part number away from the crankshaft (toward the rear of the engine).4. Put the installer in position on the locator.5. Put clean engine oil on the face of the nut and install it on the locator. Tighten the nut until the installer is at bottom.6. Remove the tooling and check the wear sleeve and seal for correct position. The wear sleeve must be even with the flywheel mounting flange.