HARNESS AS 5137223 - Caterpillar

5137223 HARNESS AS Caterpillar parts

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA5137223
513-7223
5137223

Weight: 32 pounds 14 kg.

Buy HARNESS AS 5137223 Caterpillar genuine, new aftermarket tractor parts with delivery

Compare Prices: .

As an associate, we earn commssions on qualifying purchases through the links below

Polaris Snowmobile Shaft, 19.05 x 391.414, Genuine OEM Part 5137223, Qty 1

$83.80

01 May 2025
0.7[0.32] pounds
US: Polaris Industr

Polaris Snowmobile Shaft, 19.05 x 391.414, Genuine OEM Part 5137223, Qty 1
Polaris Shaft, 19.05 x 391.414, Part 5137223, and all other Polaris Engineered service parts, deliver unmatched performance and fit for your vehicle. Each one is extensively tested in the field and meticulously crafted to match your machine. || All service parts are engineered specifically for your machine. Which means everything is designed, tested and perfected to maximize the life of your ride. || Getting Polaris Engineered parts is a decision that pays off in the long run, because it ensures there is a long run.

For full view, you need register

Information:

Illustration 3 g06009290
View of area "G"
(G) Ground stud relocation
Illustration 4 g06009299
Close up view of area "G"
(H) Correct stud to install new ring terminal on
(J) Incorrect stud to install new ring terminal on
You will also need a power ground connection for the circuit. The recommended ground point for the cab is under the cab floor. Remove the cab floor mat and floor inspection panels to access this location.Ground stud (H) is the grounding point that is recommended. This stud is a machine ground and has 200-BK wires attached. Do Not connect any ground wires to ground stud (J). This is used for machine sensor ground and has 202-BK wires attached. Electrical problems may occur if you connect other ground cables to ground stud (J).Note: Do not insert anything between the existing ring terminals and the cab stud. Place any new ground terminals between the existing terminals and the washer.
Illustration 5 g06008734
View of fuse panel
(C) Front view of fuse board showing spare fuse locations
(D) Rear view of fuse board showing connector locations
The connectors on the rear of the fuse board will have empty ports with no wire connected for each spare fuse location.
A correctly sized wire and terminal will need to be obtained to make use of these fuses.Note: Use 1 mm (0.04 inch) (16AWG) wires when connecting to the fuse panel. The ground connection should use 1 mm (0.04 inch) (16 AWG) wire in circuits up to 15 amps. For currents higher than this ( when using a common ground for other circuits) the wire should be increased in size accordingly. This ensures that the cable is of sufficient size for the 15 amp fuse rating. Smaller size wires may overheat and melt.Ignition fed power supply (Fuse F41)
Table 1
Required Parts
Item Qty Part Number Part Description
1 1 183-7754 Terminal
2 1 2L-8078 Ring Terminal
3 Suitable Amount 16 AWG) Heat shrink tubing
Illustration 6 g06008972
View of wire crimp and connector
(E) Insulation crimp
(F) Conductor crimp
Carefully crimp the terminal onto the wire using a suitable crimp tool (such as 6V-3001 Crimp Tool). Ensure