HARNESS AS-CONTROL 5152435 - Caterpillar

Illustration 1 g01150691Display (1) - The display screen shows the various views.Power indicator (2) - This indicator will light when power is present at the control.Warning indicator (3) - This indicator will light when a warning is active.Alarm indicator (4) - This indicator will light when an alarm is active.Shutdown indicator (5) - This indicator will light when a shutdown is active."LOG" button (6) - If any of the analog channels 6 through 11 have been enabled, a second instrument view screen will be available. Press the "LOG" button in order to toggle between the instrument view screens. Hold the "LOG" button for one second in order to get to the event log view."INFO" button (7) - Press the "INFO" button in order to toggle between instrument view and alarm list view. Hold the "INFO" button for one second in order to get to the information view screen.Stop button (8) - Press and hold the "Stop" button for at least 0.5 seconds in order to activate a stop. The control will stop the generator set by pulling the stop solenoid. The red LED will light in order to indicate that the stop solenoid is being pulled.Start button (9) - This is the manual start button. Press and hold the button until the engine has started. The green LED will light in order to indicate that the engine is running."Ackn" (10) - Pressing the "acknowledge" button will reset the alarms. Pressing the "acknowledge" button will also silence the buzzer. In the alarm list view, the "acknowledge" button will reset all alarms. In the instrument view, this button will only reset the alarm that is shown at the top of the screen.Lamp test (11) - Pressing this button should illuminate each LED on the front panel. The display may flash once depending on the configuration.Alarm silence (12) - This button will shut off the buzzer during an alarm. The warning will remain active until the "Ackn" button is pressed.Standby (13) - Press the standby button in order to toggle between modes. In standby mode, the control will start the engine when the Blackout Signal is received on terminal 34. After starting the engine, the control will then wait for the Delayed Stop signal. The Delayed Stop signal will initiate an automatic stop. A green LED in the Standby button will light in order to indicate that the control is in standby mode.Views
The control panel has four different views:Instrument View
The instrument view is the main view. The RPM indicator and the battery voltage are always displayed. Press the "INFO" button in order to toggle between the instrument view and the alarm list view.Alarms
The area across the top of the screen is reserved for alarms. The first alarm that occurs will appear here. There may be more than one alarm. Successive alarms will not appear at the top of the screen until the first alarm is acknowledged.Analog values
The number of horizontal analog bars that are displayed depends on the number of analog sensors