HARNESS AS-CHASSIS 5237667 - Caterpillar

Illustration 1 g02400956
Never bend the eyebolts and the brackets. Only load the eyebolts and the brackets under tension. Remember that the capacity of an eyebolt is less as the angle between the supporting members and the object becomes less than 90 degrees.When it is necessary to remove a component at an angle, only use a link bracket that is properly rated for the weight.
Use a hoist to remove heavy components. Use an adjustable lifting beam to lift the entire package. Use an adjustable lifting beam to lift the engine. All supporting members (chains and cables) should be parallel to each other. The chains and cables should be perpendicular to the top of the object that is being lifted.Some removals require lifting fixtures in order to obtain proper balance. Lifting fixtures also help to provide safety.Lifting eyes are designed and installed for each package. Alterations to the lifting eyes and/or the package make the lifting eyes and the lifting fixtures obsolete. If alterations are made, ensure that proper lifting devices are provided. Consult your Cat dealer for information regarding fixtures for proper lifting.Lifting the Entire Package
Do NOT use the engine lifting eyes or the generator lifting eyes to lift the entire package. Lifting points (3) have been provided on the base rails of the generator set for lifting the entire package. However, lifting the engine and the generator together requires special equipment and procedures. The use of a spreader bar and 4-point lifting is required. Care must be taken to ensure that the enclosure is not crushed. The enclosure package must be lifted separately with factory supplied fuel tanks. Consult your Cat dealer for information regarding fixtures for proper lifting of your complete package.Lifting the Engine Only
To remove the engine ONLY, use lifting eyes (2) that are on the engine.Lifting the Generator Only
Note: The control panel and the terminal will need to be removed before attempting to lift the generator.To remove the generator ONLY, use lifting eyes (1) that are on the generator.Lifting the Generator Set Enclosure
Lifting Instructions
Illustration 2 g02925620
Enclosure lifting locations
Use the proper lifting and rigging method to lift the whole enclosure.
The use of a spreader bar and 4-point lifting is required.
Care must be taken to ensure that the enclosure is not crushed with using lifting devices.
The enclosure package must be lifted separately with factory supplied fuel tanks.Other Instructions
Illustration 3 g02173320
(10) Drag hook (11) Shipping bracket
Shipping brackets (11) are only used for transportation in an ISO container. The brackets can be removed after site installation.
Drag hooks (10) are only used for removing the enclosure from the shipping container. Do not use the drag hooks to move the enclosure in any other manner.