HARNESS AS 5267996 - Caterpillar

Removal Procedure
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the machine. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide"for tools and supplies to collect and contain fluids in Caterpillar machines.Dispose of all fluids according to local regulations.
Extend the extender.
Place the screed on a level surface and null.
Illustration 1 g00792083
Remove bolts (1) and cover (2) .
Illustration 2 g01095133
Remove nut (4) and move inward cylinder (3) .
Illustration 3 g00797379
Loosen bolts (5) on deflector (6) .
Illustration 4 g01095138
Disconnect harness assembly (7). Remove the cable straps that hold the cable assembly to the extender.
Disconnect hose assemblies (8) .
Remove bolts and remove conduit (9) .
Disconnect harness assemblies from the burner assembly and disconnect harness assembly (10) from the extender.
Attach a suitable lifting device to extender (11). Remove bolts (12) and remove the extender. The weight of the extender is approximately 749 kg (1652 lb).Installation Procedure
Illustration 5 g01095138
Attach a suitable lifting device to extender (11). The weight of the extender is approximately 749 kg (1652 lb). Install extender (11) and bolts (12) .
Connect harness assembly (10) to the burner assembly.
Install bolts and conduit (9) .
Connect hose assemblies (8) .
Connect harness assembly (7). Attach the cable straps that hold the harness assembly to the extender.
Illustration 6 g00797379
Tighten bolts (5) on deflector (6) .
Illustration 7 g00797378
Move outward cylinder (3) and install nut (4) .
Illustration 8 g00792083
Install cover (2) and bolts (1) .