HARNESS AS-ENGINE 5401622 - Caterpillar

Installing the New Parts
Table 4
Required Parts    
Part Number     Quantity    
0L-1351 Bolt     2    
5M-2894 Hard Washer     4    
6D-3479 Clip     2    
9G-4235 Hose As     1    
9S-4182 O-Ring Plug     1    
9S-8752 Full Nut     2    
030-7961 Elbow     1    
052-0572 Swivel Tee     1    
116-1861 Plate     2    
147-0991 Hose As     1    
301-5161 Tube As     1    
6V-9027 O-Ring Seal     1    
Illustration 5 g01391255
Rear view of the engine (1) 052-0572 Swivel Tee (2) 301-5161 Tube As (3) 116-1861 Plate (4) 0L-1351 Bolt (5) 5M-2894 Hard Washer (6) 9S-8752 Full Nut (7) 6D-3479 Clip (8) 9G-4235 Hose As (9) 9S-4182 O-Ring Plug (10) 6V-9027 O-Ring Seal Follow the instructions below in order to properly install the new parts on the rear of the engine. Illustration 5 shows the new parts on the rear of the engine.
First install the 052-0572 Swivel Tee (1) to the turbocharger on the left side of the engine. Illustration 5 shows the proper location of the 052-0572 Swivel Tee (1) on the correct turbocharger.
Install the 9G-4235 Hose As (8). The 9G-4235 Hose As connects the right side turbocharger to the left side turbocharger. However make sure in order to connect the correct end of the hose to the correct turbocharger. The 9G-4235 Hose As has two different ends. Make sure that the end of the hose that has the 90° elbow is connected to the turbocharger on the right side of the engine. The other end of the 9G-4235 Hose As needs to be connected to the 052-0572 Swivel Tee that was installed in Step 1. 9G-4235 Hose As is held in place across the rear of the engine with the following parts.
Four 5M-2894 Hard Washers (5)
Two 0L-1351 Bolts (4)
Two 9S-8752 Full Nuts (6)
Two 6D-3479 Clips (7)
Two 116-1861 Plates (3)
Illustration 6 g01391310
Side view of engine (1) 052-0572 Swivel Tee (2) 301-5161 Tube As (9) 9S-4182 O-Ring Plug (10) 6V-9027 O-Ring Seal (11) 030-7961 Elbow (12) 147-0991 Hose As (13) Heat ExchangerFollow the instructions below in order to properly install the new parts on the left side of the engine. Illustration 6 shows the new parts on the left side of