HARNESS AS-ENGINE 5418673 - Caterpillar

the following procedure in order to flash program the Diesel Particulate Filter Electronic Control Module (ECM). The Diesel Particulate Filter ECM is flashed in order to upgrade the software. Flash programming of the Diesel Particulate Filter ECM must also be done if the Diesel Particulate Filter ECM has been replaced. The Caterpillar Electronic Technician (ET) contains the program WinFlash. WinFlash is used in order to load software into the ECM. The following procedure is used in order to FLASH software into the Diesel Particulate Filter ECM.Procedure
Connect the 7X-1425 Data Link Cable between the 7X-1700 Communication Adapter and the Electronic Technician.
Connect the 139-4166 Data Link Cable between the 7X-1700 Communication Adapter and the diagnostic connector of the machine.
Turn the disconnect switch and the key start switch to the ON position.
Use WinFlash in order to load the software.
Perform the necessary calibrations.