HARNESS TERMINAL STRIPS 5D3339 - Caterpillar

Transmission
Table 4
772G Caterpillar Power Shift Transmission
Travel Speeds at High Idle
Transmission Gear Speed
1 12.9 km/h (8 mph)
2 17.5 km/h (10.9 mph)
3 23.7 km/h (14.7 mph)
4 31.9 km/h (19.8 mph)
5 43.3 km/h (26.9 mph)
6 58.3 km/h (36.2 mph)
7 73.7 km/h (45.8 mph)
R 16.7 km/h (10.4 mph) Dimensions
Approximate dimensions are shown. Dimensions are shown with a flat floor body. Dimensions will vary depending on the configuration and the options.
Illustration 3 g03537517
(A) Overall Width 478 cm (15 ft 8 inch)
(B) Overall Tire Width 393 cm (12 ft 11 inch)
Illustration 4 g02292337
(C) Overall Height (body down and empty) 416 cm (13 ft. 8 inch)
(D) Overall Length 880 cm (28 ft 10 inch)
(E) Loading Height (body empty) 354 cm (11 ft 8 inch)
(F) Overall Height (body raised) 826 cm (27 ft 1 inch)
(G) Wheel Base 396 cm (13 ft 0 inch)Weights
The target gross machine operating weight is listed under "Application/Configuration Restrictions" (see below).The empty machine weight of the 772G will depend on the configuration of the machine. Weigh the empty machine to get an accurate weight. If a suitable scale is not available, contact your local Cat dealer for an approximate weight of the machine, as equipped when shipped from the factory. This weight will not include additional equipment or options that have been installed on the machine after leaving the factory.The target payload depends on the machine configuration. To calculate the target payload, subtract empty machine weight from the target gross machine operating weight.The Caterpillar payload overload policy, referred to as the 10/10/20 Overload Policy, states that no more than 10% of payloads may exceed 110% of the target payload, and no single payload shall ever exceed 120% of the maximum target payload.If this machine has a "CE" plate that is required for the European Union, the weight on the "CE" plate is based on the following:
Empty machine weight with a flat floor body and medium impact liner
Full tank of fuel
75 kg (165 lb) operatorIntended Use
The 772G Off-Highway Truck is an earthmoving machine. The 772G is classified as a dumper as described in ISO 6165:2012. This is a self-propelled wheeled machine with a rigid frame and wheel steering. This dumper has an open body that is intended for the following applications: transporting loose material and dumping loose materialApplication/Configuration Restrictions
The Target Gross Machine Operating Weight (including payload) for the 772G Off-Highway Truck is 82100 kg (181000 lb). The braking systems and the steering systems in the 772G Off-Highway Truck are in compliance with ISO standards when tested to Caterpillar Global Mining Division's 10/10/20 Overload policy.Cab structure is ROPS certified to ISO 3471:2008 up to 31646 kg (69767 lb) as a rigid frame dumper ROPS only option. This number excludes dumper body weight. This number also excludes carryback debris weight.General Operating Restrictions
Use the machine only in environments that do not contain explosive gases.
Table 5
770G and 772G Operating Restrictions Grade
Parking Brake Holding Capability(1) 15%
Maximum Side Grade Operation (Except Dumping/Spreading)(2) 15%
Maximum Side Grade for Dumping/Spreading(3) 0%
Maximum Negative Grade (uphill) for Dumping/Spreading(4)