HARNESS AS 5I8269 - Caterpillar

Note: Lifting capacities are based on a standard machine with the following conditions:
lubricants
full fuel tank
steel track
cab
75 kg (165 lb) operatorLifting capacities will vary with different work tools and attachments. Consult your Caterpillar dealer regarding the lifting capacities for specific work tools and attachments.Note: Lifting capacities should be used as a guide. Work tools, uneven ground conditions, soft ground conditions, or poor ground conditions have effects on lifting capacities. The operator is responsible for being aware of these effects.Special hazards (toxic gases, ground conditions, etc.) require special precautions. The operator must determine whether special hazards exist in each application. The operator shall perform the appropriate steps to eliminate the hazard. The operator shall perform the appropriate steps to reduce the hazard.For European applications, the lifting capacities are defined by "ISO 10567 2007". The lifting capacities are defined as the lower value of 75% of the static tipping capacity or 87% of the hydraulic lift capacity.This machine may be equipped with various sticks. Lifting capacities may vary between the different sticks. Measure the distance on the stick between the boom hinge pin and the work tool hinge pin. This distance will inform you of the size of the stick that is equipped on the machine.Note: Certain European countries require a load sensing indicator and a stick and boom lowering control device if 1000 kg (2200 lb) or more is lifted during object handling applications. These countries also require a load sensing indicator and a stick and boom lowering control device if a moment is generated that is greater than or equal to 40000 N m (29500 lb ft) during the object handling applications. Please comply with local and national requirements. To ensure compliance in these countries, (a) do not lift a load of 1000 kg (2200 lb) or more if the machine is not equipped with a load sensing indicator and a stick and boom lowering control device, and (b) do not equal or exceed a moment of 40000 N m (29500 lb ft) in object handling applications if the machine is not equipped with a load sensing indicator and a stick and boom lowering control device.Symbols Found in the Lifting Capacity Charts
Below are symbols that are commonly found on lifting capacity charts for track excavators.Note: Depending on the machine configuration, some symbols may not be used.
Measurements are provided in millimeters and inches
Lift Capacities are provided in kilograms and pounds
Load is limited by hydraulic lifting capacity rather than by a tipping load
Lift point radius
Lift point height
Lifting capacity over the front of the machine
Lifting capacity over the side of the machine
Heavy Lift ONFixed Gauge (Reach Boom)(900 MM TG Shoe)
Illustration 1 g03732080
Lift Chart Above: 349F LXE, 6900 mm (271 inch) reach boom (heavy lift off), 3900 mm (154 inch)stick, and 900 mm (36 inch) TG track shoes
Illustration 2 g03732085
Lift Chart Above: 349F LXE, 6900 mm (271 inch) reach boom (heavy lift on), 3900 mm (154 inch)stick, and 900 mm (36 inch) TG track shoes
Variable Gauge (Reach Boom)(600 MM TG