HARNESS AS 6G2951 - Caterpillar

Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
B 2P-8312 Retaining Ring Pliers 1
C 1U-8848 Axle Shaft Installer 1 Note: Cleanliness is an important factor. Before the installation procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.
Illustration 1 g01191336
Illustration 2 g01191553
Illustration 3 g01191490
Install retaining ring (7). Retaining ring (7) will be used to prevent damage to Tooling (C). Attach a suitable lifting device to axle shaft (5). The weight of axle shaft (5) is approximately 26 kg (57 lb). Install axle shaft (5). Use Tooling (C) to align the splines of axle shaft (5) into the differential .
Illustration 4 g01191484
Illustration 5 g01191546
Remove retaining ring (7). Install sun gear (6). Use a screwdriver to raise axle shaft (5) so that sun gear (6) can be fully installed without pushing axle shaft (5) further into the final drive. Install retaining ring (7).
Illustration 6 g01191343
Illustration 7 g01416760
Install O-ring seal (4). Install cover (2) for the final drive. Install bolts (3). Install drain plug (1) at the bottom of cover (2) Tighten drain plug (1) to a torque of 150 15 N m (111 11 lb ft).
Check the oil level of the final drive. Add oil, if necessary. Refer to Operation and Maintenance Manual, "Final Drive Oil Level -Check".