HARNESS AS 6I1671 - Caterpillar

In order to jump start this machine, a jump start receptacle must be used.Failure to do so could cause damage to the electrical system of the machine.
Illustration 1 g03477736An auxiliary jump-start receptacle must be installed on this machine prior to jump starting. Installation of the auxiliary jump-start receptacle must be performed by a trained technician or your Cat dealer. There are two cable assemblies that can be used to jump-start the stalled machine. You can jump-start the stalled machine from another machine that is equipped with an auxiliary starting receptacle or with an auxiliary power pack. Your Cat dealer can provide the correct cable lengths for your application.
Determine the reason that the engine will not start. Reference: Refer to Special Instruction, SEHS7768 for more information on using the 6V-2150 Starting/Charging Analyzer. Use this procedure even if the machine does not have a diagnostic connector.
Engage the parking brake. Lower all work tools to the ground.
Turn the start switch key on the stalled machine to the OFF position. Turn off all accessories.
Turn ON the battery disconnect switch on the stalled machine.
Move the machine that is being used as a power source close to the stalled machine. The jump-start cables should reach the batteries on both machines. DO NOT ALLOW THE MACHINES TO CONTACT EACH OTHER.
Stop the engine on the machine that is being used as a power source. If you use an auxiliary power source, turn off the charging system.
Connect the appropriate jump-start cable to the auxiliary starting receptacle on the stalled machine.
Connect the other end of the jump-start cable to the auxiliary starting receptacle of the machine that is being used as a power source.
Start the engine on the machine that is being used as a power source or energize the charging system on the auxiliary power source.
Allow the machine that is being used as a power source to charge the batteries for 2 minutes.
Attempt to start the stalled engine.
Immediately after the stalled engine starts, disconnect the jump-start cable from the power source.
Disconnect the other end of the jump-start cable from the stalled machine.
Conclude the failure analysis on the starting charging system of the stalled machine, as required. Check the machine while the engine is running and the charging system is in operation.