HARNESS AS 6Y2167 - Caterpillar

6Y2167 HARNESS AS Caterpillar parts 446, 446B, IT12B, IT14B, RT100

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA6Y2167
6Y-2167
6Y2167

Weight: 0.40 pounds 0 kg.

Buy HARNESS AS 6Y2167 Caterpillar genuine, new aftermarket tractor parts with delivery
BACKHOE LOADER, TELEHANDLER,

Show more prices Caterpillar parts

Compatible equipment models: 6Y2167:

BACKHOE LOADER 446 446B

INTEGRATED TOOLCARRIER IT12B IT14B

TELEHANDLER RT100 Caterpillar

Number on catalog scheme: 1

Caterpillar 6Y2167 Parts scheme HARNESS AS

For full view, you need register

Information:

Illustration 1 g01177082
Schematic of the Reverse SwitchThis diagnostic code is recorded when status of the direction switch is wrong. When the switch is in REVERSE, the Normally Open circuit is grounded and the Normally Closed circuit is open. When the switch is in FORWARD or NEUTRAL, the Normally Open circuit is open and the Normally Closed circuit is grounded. A diagnostic code is recorded when the status of the direction switch does not match the signal from the position sensor (direction selector). There will be no backup system for the position sensor (direction selector) if the sensor fails. Test Step 1. CHECK THE DIRECTION SWITCH.
Check the screws that hold the direction switch to the console. Tighten any loose screws.
If the problem persists, loosen the screws on the direction switch and rotate the switch slightly.
Tighten the screws. Change the direction of the machine and then determine if the diagnostic code is still present.
If the problem still exists, loosen the screws on the direction switch. Rotate the switch in the opposite direction slightly.
Tighten the screws. Change the direction of the machine and then determine if the diagnostic code is still present.
Determine if the CID 2122 FMI 07 is present.Expected Result:CID 2122 FMI 07 is present. Results:
OK - CID 2122 FMI 07 is present. Repair: The problem has not been corrected. The direction switch may have failed. Replace the direction switch. Exit this procedure and perform the diagnostic code procedure again. If the problem persists, the ECM may have failed. Prior to replacing an ECM, always contact your dealership for possible consultation with Caterpillar. This consultation may greatly reduce repair time. See the Troubleshooting, "Electronic Control Module (ECM) - Replace".STOP
NOT OK - CID 2122 FMI 07 is not present. Repair: The problem does not exist at this time. The initial problem was probably caused by a poor electrical connection or a short at one of the harness connectors that was disconnected and reconnected. Resume normal machine operation.STOP