HARNESS ASSEMBLY 9N4227 - Caterpillar

Installation Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     138-7575     Link Bracket     2    Note: Cleanliness is an important factor. Before assembly, all parts should be thoroughly cleaned in cleaning fluid. Allow the parts to air dry. Wiping cloths or rags should not be used to dry parts. Lint may be deposited on the parts which may cause later trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement.
Illustration 1 g00649932
Illustration 2 g00649931
Install two bolts (22) on oil filter (11) and Tooling (A). Attach a strap and a suitable lifting device to the oil filter. Position the oil filter back to the original location.
Install four bolts (23) and the washers on bracket (24) .
Illustration 3 g00649929
Install bolt (19) on clip (20) on the bottom of oil filter (11). Install nut (20) and the two washers.
Illustration 4 g00649928
Install the O-ring seal on hose assembly (17). Connect hose assembly (17) on oil filter (11). Install four bolts (16), the four washers, and two half flanges (15). Install the O-ring seal on hose assembly (18). Connect hose assembly (18) on oil filter (11). Install four bolts (13), the four washers, and two half flanges (12). Install two nuts (10) and connect wires (9) on sending unit (14).
Illustration 5 g00649927
Install cover (5). Install bolt (7), the washer, and bracket (8) .
Illustration 6 g00649926
Install bolt (4), the two washers,and the nut. Install bolt (6) and the washer. Turn handle (1), and close cover (2). Install padlock (3) .