HEAD GP- 0R1080 - Caterpillar

$ Disable Screen - This key limits an operator form being able to access specific on-board screens that are displaying the CAES productivity information.The code in Table 5 prevents operator access to UtilizationCycleVolumeinformation.
Table 5
Disable Screen Access    
    $ Disable Screen Utilization =0
$ Disable Screen Cycle =0
$ Disable Screen Volume =0    ReferenceFor additional information on productivity, refer to Systems Operation, "Productivity File".Keys for CAESultra, and CAESultra with KEA Server
MMS Interface Keys
$ Send Loads To MMS - This key enables information from the "Dispatch" system of the Modular Mining System$ Baud - This key sets the baud rate for the serial ports that are available to CAES.The code in Table 6 must be used if communications with Modular Mining is desired. Other than removing the space in front of the line, no changes to these lines are necessary.
Table 6
Modular Mining Keys    
    $ Send Loads To MMS =0
$ Baud 1 =9600    Swath Velocity Limits
$ Swath Velocity Limit - When the machine exceeds a specified speed, this key will stop the machine from writing to the "orestat.cat" and the "currelev.cat" file.
$ XXXXX Swath Velocity Limit =nnnn.nProductivity Keys
$ Prod Report Mined Out Buckets - This key turns off the logging of buckets when the material type is determined to be "mined out".
$ Prod Report Mined Out Buckets =1ReferenceFor additional information on productivity, refer to Systems Operation, "Productivity File".Automatic Ore Status Maintenance
Automatic ore status maintenance keys create a new on-board "Orestat.cat" file whenever a machine either begins working on a new, predefined elevation, or else when a design file with a different group association becomes the primary file. If the elevation mode is selected, then keys must be used in order to assign specific benches. Specific benches are defined by explicitly naming the bench elevations, or else by providing a base elevation and an offset from that elevation for subsequent benches. If the group mode is selected, then CAESultra creates and uses a different Orestat.cat file for each group that the primary material design files are associated with. By default, CAESultra creates only one Orestat.cat file regardless of either the elevation or the group association of the file. Note: This is only an on-board key. The groups in the office are not affected by this selection.$ Ore Status Maint Enable - Enables automatic Ore Status file update. Values are: L = Level, G = Group, or Off. file. In the following code, automatic ore status maintenance will be based upon the group of the Prime Material Design.
$ Ore Status Maint Enable =L$ Ore Status Maint Retention - The key sets the number of "Ore Status" files that CAES will retain for automatic ore status maintenance. In the following code, up to five "Ore Status "files will be retained by CAES.
$ Ore Status Maint Retention =5$ Elevation Base - This key sets the reference elevation for the "$ Elevation Offset" key.$ Elevation Offset - This key sets the increment from the reference elevation specified by the "$ Elevation Base" key.$