HEAD GP-CYL -UTN 0R2175 - Caterpillar

Installation Procedure
Illustration 1 g00375454
Position lift cylinder rod (1) over trunnion (2) .
Illustration 2 g00375455
Position end cap (3) under trunnion (2) .
Illustration 3 g00375457
Illustration 4 g00375458
Install shims (4) on the front of end cap (3) and the back of end cap (3) .
Illustration 5 g00375460
Install washers and bolts (5) .
Tighten bolts (5) .Note: Use Steps 1 through 5 to connect the lift cylinder that is on the right side of the machine.
Illustration 6 g00375462
Install center pin (6) .
Illustration 7 g00375594
Position end cap (7) that is for the push arm over trunnion (8) .Note: Use the machine hydraulics system to move push arm in position on both sides of the machine.
Illustration 8 g00375595
Install end cap (10) over trunnion (8) with two bolts (11). Measure the gap that is between end cap (10) and end cap (7) that is for the push arm. Record the measurement.
Remove bolts (11) and end cap (10) .Note: Use the number of shims that equals the distance that was measured in Step 8.
Illustration 9 g00375596
Install end cap (10) with shims (12), bolts (11) and nuts (13) .
Tighten nuts (13) .Note: Use Steps 8 through 11 to connect the push arm to the left side of the machine.