HEAD GP-CYL BSC 0R7467 - Caterpillar

Be sure no one is working on or near the machine to prevent injury. Keep the machine under control at all times to prevent injury.Reduce engine speed when maneuvering in tight quarters or when breaking over a rise.Select the speed range necessary before starting downgrade. Do not change gears while going downhill.A good practice is to use the same speed range going downgrade that would be used to go up the grade.Do not allow the engine to overspeed downhill. Use the service brake pedal to reduce engine overspeed going downhill.When the load will be pushing the machine, put the transmission selector lever in FIRST speed before starting downhill.1. Adjust the operator's seat.2. Fasten the seat belt. 3. Raise all attachments enough to clear any obstructions. 4. Push down on the brake pedal to keep the machine from moving. 5. Pull the lock lever up to disengage the parking brake and to unlock the transmission lever. 6. On power shift machines, move the transmission control lever to the desired direction and speed. Release the brake pedal to release the brakes and allow the machine to move.On direct drive machines, push the flywheel clutch pedal down to release clutch and apply the brakes. Move the transmission directional control lever to the desired direction. Move the transmission speed control lever to the desired speed. Release the flywheel clutch pedal to release the brakes and allow the machine to move. 7. Move the governor control lever to the desired engine speed.8. Drive the machine forward for best visibility and control.Direction and Speed Changing
Power Shift
Speed and directional changes at full engine speed are possible on machines with power shift transmission. However, for operator comfort and maximum service life of transmission components, decelerating and/or braking when changing directions is recommended.1. Decrease the engine speed by pushing the governor control in, or by pushing the decelerator pedal (if equipped) down. 2. Push the brake pedal down to stop the machine. 3. Move the transmission control lever to