HEAD GP-CYL BSC 10R9942 - Caterpillar

The information supplied in this service letter may not be valid after the termination date of this program. Do not perform the work outlined in this Service Letter after the termination date without first contacting your Caterpillar product analyst.
This Program must be administered as soon as possible. When reporting the repair, use "PI3605" as the Part Number, "7751" as the Group Number, "56" as the Warranty Claim Description Code and "T " as the SIMS Description Code. Exception: If the repair is done after failure, use "PI3605" as the Part Number, "7751" as the Group Number, "96" as the Warranty Claim Description Code, and " Z" as the SIMS Description Code.
Completion Date
April 30, 1993Termination Date
October 31, l993Problem
The left hand battery needs to be rotated l80 degrees on certain D4H, D4H LGP, and D4H XL Tractors to provide clearance for the battery terminals.
Affected Product
Model & Identification Number
D4H (PS) (8PB5500-5559)
D4H (DD) (2AC5500-5520)
D4H LGP (PS) (9GJ1-134)
D4H LGP (DD) (4NK1-120)
D4H XL (8PJ1-135)
Parts Needed
Not Applicable
Action Required
See the attached procedure.
Owner Notification
U.S. and Canadian owners will receive the attached Owner Notification.
Service Claim Allowances
This is a 2-hour job.
U.S. and Canadian Dealers Only - Eligible dealers may enter a Type 2 SIMS Report.
Parts Disposition
Handle the parts in accordance with your Warranty Bulletin on warranty parts handling.
MAKE EVERY EFFORT TO COMPLETE THIS PROGRAM AS SOON AS POSSIBLE.
Attach.
(1-Owner Notification)(2 -Rework Procedure)Copy Of Owner Notification For U.S. And Canadian Owners
Rework Procedure
1. Disconnect the battery terminal on the left hand battery.2. Remove the 8G5635 and 8G5617 Battery covers.3. After the covers are removed, loosen all battery cable hold down clamps. Refer to Illustration 1.4. Loosen the 6T1832 Angle that holds the left hand battery in place, and remove the battery.
Illustration 15. Pull the negative cable of the left hand battery to obtain enough slack to connect the cable to the negative post of the battery once the battery is rotated 180 degrees from its original position. Refer to Illustration 2.6. Install the battery with the posts rotated 180 degrees from their original position. Refer to Illustration 2.7. Route the battery cables, positioning the battery cable hold down clamps as necessary so that the cables do not rub on any corners or sharp edges.8. Connect the battery cable terminal to the correct battery posts. Refer to Illustration 2.9. Install the battery covers
Illustration 2